سلام.
اینم از مودم من :
Only plain text email is forwarded by the Discuss@Linmodems.org List Server,
as HTML can contain viruses. Use as the email Subject Line:
YourName, YourCountry kernel 2.6.27-7-generic
With this Subject Line cogent experts will be alerted, and useful case names left in the Archive.
YourCountry will enable Country specific guidance. Linux experts in YourCountry
can be found through: http://www.linux.org/groups/index.html.
They will know your Country's modem code, which may be essential for dialup service.
Responses from Discuss@Linmodems.org are sometimes blocked by an Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org
-------------------------- System information ----------------------------
CPU=i686,
Linux version 2.6.27-7-generic (buildd@rothera) (gcc version 4.3.2 (Ubuntu 4.3.2-1ubuntu10) ) #1 SMP Fri Oct 24 06:42:44 UTC 2008
scanModem update of: 2008_11_06
There are no blacklisted modem drivers in /etc/modprobe* files
Attached USB devices are:
ID 0518:0001 EzKEY Corp. USB to PS2 Adaptor v1.09
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 04d9:0499 Holtek Semiconductor, Inc.
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0002 Linux Foundation 2.0 root hub
USB modems not recognized
For candidate card in slot 04:00.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
04:00.0 2000:2800 163c:2801 Modem: Smart Link Ltd. SmartPCI2800 V.92 PCI Soft DFT
Modem interrupt assignment and sharing:
220: 0 0 PCI-MSI-edge eth0
--- Bootup diagnostics for card in PCI slot 04:00.0 ----
[ 0.842201] PCI: 0000:04:00.0 reg 10 32bit mmio: [d6000000, d6ffffff]
[ 0.842252] pci 0000:04:00.0: PME# supported from D3hot D3cold
[ 0.842257] pci 0000:04:00.0: PME# disabled
[ 2.745330] serial 0000:04:00.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20
[ 2.745338] serial 0000:04:00.0: PCI INT A disabled
The PCI slot 04:00.0 of the modem card may be disabled early in
a bootup process, but then enabled later. If modem drivers load
but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
Send dmesg.txt along with ModemData.txt to discuss@linmodems.org
if help is needed.
For candidate card in slot 00:1b.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:1b.0 8086:27d8 1458:a002 Audio device: Intel Corporation 82801G
Modem interrupt assignment and sharing:
16: 44953 0 IO-APIC-fasteoi uhci_hcd:usb5, HDA Intel, nvidia
--- Bootup diagnostics for card in PCI slot 00:1b.0 ----
[ 0.840143] PCI: 0000:00:1b.0 reg 10 64bit mmio: [d7000000, d7003fff]
[ 0.840278] pci 0000:00:1b.0: PME# supported from D0 D3hot D3cold
[ 0.840297] pci 0000:00:1b.0: PME# disabled
[ 18.801183] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 18.801257] HDA Intel 0000:00:1b.0: setting latency timer to 64
The PCI slot 00:1b.0 of the modem card may be disabled early in
a bootup process, but then enabled later. If modem drivers load
but the modem is not responsive, read DOCs/Bootup.txt about possible fixes.
Send dmesg.txt along with ModemData.txt to discuss@linmodems.org
if help is needed.
===== Advanced Linux Sound Architecture (ALSA) diagnostics =====
The ALSA packages provide audio support and also drivers for some modems.
ALSA diagnostics are written during bootup to /proc/asound/ folders.
The ALSA verion is 1.0.17
The modem cards detected by "aplay -l" are: None
The /proc/asound/pcm file reports:
-----------------------
00-02: ALC888 Analog : ALC888 Analog : capture 1
00-01: ALC888 Digital : ALC888 Digital : playback 1 : capture 1
00-00: ALC888 Analog : ALC888 Analog : playback 1 : capture 1
about /proc/asound/cards:
------------------------
0 [Intel ]: HDA-Intel - HDA Intel
HDA Intel at 0xd7000000 irq 16
PCI slot 00:1b.0 has a High Definition Audio Card
The drivers are in the kernel modules tree at:
/lib/modules/2.6.27-7-generic/kernel/sound/pci/hda/snd-hda-intel.ko
=== Finished firmware and bootup diagnostics, next deducing cogent software. ===
Predictive diagnostics for card in bus 04:00.0:
Modem chipset detected on
NAME="Modem: Smart Link Ltd. SmartPCI2800 V.92 PCI Soft DFT "
CLASS=0703
PCIDEV=2000:2800
SUBSYS=163c:2801
IRQ=20
IDENT=slamr
For candidate modem in: 04:00.0
0703 Modem: Smart Link Ltd. SmartPCI2800 V.92 PCI Soft DFT
Primary device ID: 2000:2800
Support type needed or chipset: slamr
----------------end Softmodem section --------------
Writing DOCs/Intel.txt
The modem is supported by the Smartlink
plus the slmodemd helper utility. Read the
DOCs/Smartlink.txt and Modem/DOCs/YourSystem.txt for follow through guidance.
For 2.6.27-7-generic compiling drivers is necessary. As of October 2007 the current packages at
http://linmodems.technion.ac.il/packages/smartlink/ are the
ungrab-winmodem-20070505.tar.gz and slmodem-2.9.11-20080126.tar.gz
Writing DOCs/Smartlink.txt
============ end Smartlink section =====================
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset not detected on
NAME="Audio device: Intel Corporation 82801G "
CLASS=0403
PCIDEV=8086:27d8
SUBSYS=1458:a002
IRQ=16
HDA=8086:27d8
SOFT=8086:27d8.HDA
High Definition Audio (HDA) cards MAY host a modem chip in their Subsystem,
and many are supported by the ALSA audio+modem driver snd-hda-intel
A modem was not detected on HDA card 8086:27d8.
If another modem card is present, then most likely 8086:27d8 does not host a modem.
If another modem card has not been detected, then possibilities are:
1) A Conexant modem chip is present on 8086:27d8, as Conexant chips
are frequently not detectable by ALSA diagnostics
2) The modem may be of the older non-PCI Controller Chipset (hardware) type.
Try detection with Root permission:
sudo wvdialconf /etc/wvdial.conf
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801G
Primary device ID: 8086:27d8
Subsystem PCI_id 1458:a002
Softmodem codec or chipset from diagnostics:
from Archives:
Support type needed or chipset:
Support can likely be achieved through two mutually exclusive alternatives:
1) The hsfmodem software for Conexant chipset modems: Read DOCs/Conexant.txt
The following ALSA alternative CANNOT work with Conexant modems.
2) An ALSA modem driver plus slmodemd. Read DOCs/Smartlink.txt for details, and
to test get the package SLMODEMD.gcc4.3.tar.gz from:
http://linmodems.technion.ac.il/packages/smartlink/
----------------end Softmodem section --------------
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.3.2
and the compiler used in kernel assembly: 4.3.2
Minimal compiling resources appear complete:
make utility - /usr/bin/make
Compiler version 4.3
linuc_headers base folder /lib/modules/2.6.27-7-generic/build
However some compilations and executable functions may need additional files,
in the FileNames.h (so called kernel "h"eaders) collection installed in /usr/include/ .
For martian_modem, additional required packages are needed. The also required headers of package libc6 are commonly installed by default.
Compiling hsfmodem drivers does require linux-libc-dev and libc6-dev packages, for kernels 2.6.24 and later versions.
In not included on your install CD, search for them at http://packages.ubuntu.com
or comparable Repository for other Linux distros.
When compiling ALSA drivers, the utility "patch" will also be needed.
If a driver compilation fails, with message including some lack of some FileName.h (stdio.h for example), then
Some additional kernel-header files need installation to /usr/include. The minimal additional packages are libc6-dev
and any of its dependents, under Ubuntu linux-libc-dev
If an alternate ethernet connection is available,
$ apt-get update
$ apt-get -s install linux-kernel-devel
will install needed packages.
For Debian/Ubuntu related distributions, run the following command to display the needed package list:
Otherwise packages have to be found through http://packages.ubuntu.com
Once downloaded and transferred into a Linux partition,
they can be installed alltogether with:
$ sudo dpkg -i *.deb
Checking settings of: /etc/ppp/options
asyncmap 0
noauth
crtscts
lock
hide-password
modem
proxyarp
lcp-echo-interval 30
lcp-echo-failure 4
noipx
In case of a message like:
Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
Read Modem/DOCs/YourSystem.txt concerning other COMM channels: eth0
Which can interfere with Browser naviagation.
Don't worry about the following, it is for experts should trouble shooting be necessary.
==========================================================
# start/stop the daemon when the USB modem is connected
KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
Checking for modem support lines:
--------------------------------------
/device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
Within /etc/udev/ files:
/etc/udev/rules.d/030_sl-modem-daemon.rules:# start/stop the daemon when the USB modem is connected
/etc/udev/rules.d/030_sl-modem-daemon.rules:KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
/etc/udev/sl-modem-daemon.rules:# start/stop the daemon when the USB modem is connected
/etc/udev/sl-modem-daemon.rules:KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
Within /etc/modprobe.conf files:
/etc/modprobe.d/sl-modem-daemon.modutils:install slamr modprobe --ignore-install ungrab-winmodem ; modprobe --ignore-install slamr; test -e /dev/slamr0 || (/bin/mknod -m 660 /dev/slamr0 c 242 0 2>/dev/null && chgrp dialout /dev/slamr0)
/etc/modprobe.d/blacklist-modem:# Uncomment these entries in order to blacklist unwanted modem drivers
/etc/modprobe.d/blacklist-modem:# blacklist snd-atiixp-modem
/etc/modprobe.d/blacklist-modem:# blacklist snd-via82xx-modem
/etc/modprobe.d/alsa-base:options snd-atiixp-modem index=-2
/etc/modprobe.d/alsa-base:options snd-via82xx-modem index=-2
Within any ancient /etc/devfs files:
Within ancient kernel 2.4.n /etc/module.conf files:
--------- end modem support lines --------
راستی من همین قدر که خوندم فهمیدم که مودمم SmartLink هست و sl-modem-daemon_2.9.10+2.9.9d+e-pre2-5ubuntu4_i386 رو هم دانلود و نصب کردم.
.ولی بازم مودم رو نمیشناسه.(با دستور Wvdial چیزی پیدا نمیکرد)
راستی ویکی رو هم خوندم ولی نفهمیدم.اگه میشه خودتون توضیح بدید(ابزار PPP Gnome هم که مال اتصال Dial-up توی uubntu 8.10 هست رو هم دانلود کردم)
موضوع: مشخصات مودم من ! (دفعات بازدید: 4320 بار)
