مشکل در نصب tinycore روی فلش

[mb2000]

من می خواستم توزیع تینی کور را روی فلش نصب کنم اما از مرحله ۳ به بعد نمی دانم چطور انجام دهم و چیزی روی فلش ذخیره نمی شود.
اگر کسی می داند لطفا کمک کند
This is a shameless modification of the old DSL instructions (written by SaidinUnleashed, to give full credit).  This was performed from a Debian Sid x86 system.  The USB stick is /dev/sdc1.

1) Install necessary tools.  On Debian this is syslinux, mtools, and dosfstools:

Code:
aptitude install syslinux mtools dosfstools

2) Partition the thumb drive.  I used fdisk to partition the thumb drive into one large FAT32 partition.  The following directions are from memory but should be correct.

Code:
umount /dev/sdc1 # Never use fdisk on a mounted partition
fdisk /dev/sdc1
d
1
d
2
d
3
d  # These commands delete all partitions currently on the device
n
p
1 # This makes a new primary partition
a
1 # This makes it bootable
t
1
b # This makes it FAT 32
w

Now, I always overwrite the drive's mbr in case it was used for booting from grub sometime in the past.  This is not normally necessary.

Code:
dd if=/usr/lib/syslinux/mbr.bin of=/dev/sdc

Now, make a FAT 32 partition:

Code:
mkfs.vfat -F 32 /dev/sdc1

3) Copy over the files

You will need to mount the iso image using loopback and then copy over the files.

Code:
mkdir /mnt/iso
mount -o loop tinycore_1.0rc1.iso /mnt/iso
mkdir /mnt/usb
mount /dev/sdc1 /mnt/usb
cp /mnt/iso/* /mnt/usb

4) Set up syslinux

Since the ISO uses isolinux, we will need to make some changes

Code:
mv /mnt/iso/boot/isolinux /mnt/iso/boot/syslinux
mv /mnt/iso/boot/syslinux/isolinux.cfg /mnt/iso/boot/syslinux/syslinux.cfg
rm -f /mnt/iso/boot/syslinux/isolinux.bin # This didn't stop it from working for me, but I'm not sure if this file is necessary.
syslinux /dev/sdc1