من درایور کارت شبکه رو دارم اما نمی تونم نصبش کنم لطفا راهنمایی کنید
توی فایل read me درایور یه چیزایی نوشته ولی من سر در نیاوردم :
Linux* Base Driver for the Atheros(R) AR8121/AR8113 PCI-E Ethernet Adapter
==========================================================================
Contents
========
- In This Release
- Building and Installation
- Command Line Parameters
- Additional Configurations
- Known Issues
- Support
In This Release
===============
This file describes the Linux* Base Driver for the Atheros(R) AR8121/AR8113 PCI-E
Ethernet Adapter, version 1.0.0.5 This driver supports the 2.4.x and 2.6.x kernels.
This driver is only supported as a loadable module at this time. Atheros is not
supplying patches against the kernel source to allow for static linking of
the driver. For questions related to hardware requirements, refer to the
documentation supplied with your Atheros(R) adapter. All hardware
requirements listed apply to use with Linux.
Building and Installation
=========================
To build a binary RPM* package of this driver, run 'rpmbuild -tb
<filename.tar.gz>'. Replace <filename.tar.gz> with the specific filename of
the driver.
NOTE: For the build to work properly, the currently running kernel MUST match
the version and configuration of the installed kernel sources. If you
have just recompiled the kernel reboot the system now.
RPM functionality has only been tested in Red Hat distributions.
1. Move the base driver tar file to the directory of your choice. For example,
use /home/username/arl1e or /usr/local/src/arl1e.
2. Untar/unzip archive:
tar zxf arl1e-x.x.x.x.tar.gz
3. Change to the driver src directory:
cd arl1e-x.x.x.x/src/
4. Compile the driver module:
make install
The binary will be installed as:
/lib/modules/<KERNEL VERSION>/kernel/drivers/net/arl1e.[k]o
The install locations listed above are the default locations. They might
not be correct for certain Linux distributions. For more information,
see the ldistrib.txt file included in the driver tar.
5. Install the module:
insmod arl1e <parameter>=<value>
6. Assign an IP address to the interface by entering the following, where
x is the interface number:
ifconfig ethx <IP_address>
7. Verify that the interface works. Enter the following, where <IP_address>
is the IP address for another machine on the same subnet as the interface
that is being tested:
ping <IP_address>
موضوع: مشکل در نصب کارت شبکه (دفعات بازدید: 12184 بار)
