آقا این موضوع رو من تازه فهمیدم ولی انگاری یه کم دیر شده و هاردم به فنا رفته:
193 Load_Cycle_Count 0x0032 001 001 000 Old_age Always - 283739
برای دو سال زیاده؟
در ضمن یه سری ارور هم توی خروجی smartctl هست:
smartctl 6.2 2013-07-26 r3841 [x86_64-linux-3.13.5-1-ARCH] (local build)
Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 5400.6
Device Model: ST9500325AS
Serial Number: 5VESDESB
LU WWN Device Id: 5 000c50 049879315
Firmware Version: 0003SDM1
User Capacity: 500,107,862,016 bytes [500 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 5400 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Sat Jul 19 16:21:30 2014 IRDT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 136) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 099 006 Pre-fail Always - 124606883
3 Spin_Up_Time 0x0003 098 098 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 097 097 020 Old_age Always - 3628
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 1
7 Seek_Error_Rate 0x000f 078 060 030 Pre-fail Always - 71147795
9 Power_On_Hours 0x0032 093 093 000 Old_age Always - 6479
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 097 097 020 Old_age Always - 3542
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 096 096 000 Old_age Always - 4
188 Command_Timeout 0x0032 100 097 000 Old_age Always - 8590065772
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 058 054 045 Old_age Always - 42 (Min/Max 40/42)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 155
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 0
193 Load_Cycle_Count 0x0032 001 001 000 Old_age Always - 283739
194 Temperature_Celsius 0x0022 042 046 000 Old_age Always - 42 (0 16 0 0 0)
195 Hardware_ECC_Recovered 0x001a 051 045 000 Old_age Always - 124606883
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 4
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 4 occurred at disk power-on lifetime: 2754 hours (114 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 00:12:14.844 READ FPDMA QUEUED
27 00 00 00 00 00 e0 00 00:12:14.843 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3]
ec 00 00 00 00 00 a0 00 00:12:14.842 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 00:12:14.841 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 00:12:14.841 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3]
Error 3 occurred at disk power-on lifetime: 2754 hours (114 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 00:12:12.333 READ FPDMA QUEUED
61 00 10 ff ff ff 4f 00 00:12:12.333 WRITE FPDMA QUEUED
61 00 58 ff ff ff 4f 00 00:12:12.332 WRITE FPDMA QUEUED
27 00 00 00 00 00 e0 00 00:12:12.332 READ NATIVE MAX ADDRESS EXT [OBS-ACS-3]
ec 00 00 00 00 00 a0 00 00:12:12.330 IDENTIFY DEVICE
Error 2 occurred at disk power-on lifetime: 2754 hours (114 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 00:12:07.999 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 00:12:07.998 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 00:12:07.998 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 00:12:07.997 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 00:12:07.995 READ FPDMA QUEUED
Error 1 occurred at disk power-on lifetime: 2749 hours (114 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 ff ff ff 4f 00 06:19:51.573 READ FPDMA QUEUED
60 00 28 ff ff ff 4f 00 06:19:50.391 READ FPDMA QUEUED
60 00 28 ff ff ff 4f 00 06:19:47.914 READ FPDMA QUEUED
61 00 08 ff ff ff 4f 00 06:19:47.727 WRITE FPDMA QUEUED
61 00 08 ff ff ff 4f 00 06:19:47.727 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 6477 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
چیز مهمیه؟
موضوع: acpi و صدمه به هارد در نوت بوک (مهم) [مجددا باز شده] (دفعات بازدید: 197311 بار)
